The position of Automation Technician is responsible for installation, maintenance, inspection, and repair on all land based oil field instrumentation, control systems (POCs, ROCs, PLCs), SCADA, analyzers and electrical equipment. This role also performs preventative maintenance and troubleshoots I&E issues. 

• Install, maintain, inspect, troubleshoot, repair and perform preventative maintenance on all field instrumentation, control systems, analyzers and electrical equipment. 

• Responsible for prompt and accurate diagnosis of minor problems and the implementation of corrective action.
• Consult directly with equipment vendors on problems for resolution as necessary. 

• Coordinate and conduct well maintenance activities on wells and batteries for new installs/upgrades and recurring problems where root cause cannot be identified by Well Tech. 

• Coordinate and conduct maintenance activities on end devices to include pre-programming of transmitters with hart communicator and ensure data accuracy on all fluid and gas measurement meters. 

• Conduct in depth failure analysis on repeat equipment failures. 

• Implement design for wells within guidelines of automation standards. 

• Respond and provide automation support during all outages. 

• Work off of assigned schedule and maintain zero out of compliance work orders. 

• Provide analytical support on problem wells.

• Provide input on new technologies.

• Able to perform general PM work: testing end devices, temperature shutdowns, pressure switches, and level shutdowns. 

• Conduct evaluation tests on valves, motors, instruments, etc. 

• Knowledge of RTUs.
• Experience with Fisher,  Rockwell, ABB, Allen Bradley, and IDEC.
• Understanding of digital and analog I/O, programming, and troubleshooting. 

• Must be proficient in troubleshooting using loop drawing, schematics, ladder logic, electrical one-line, and P&I drawings. 

• Proficient in maintaining process control loops, electronic controls, valves, and transmitters. 

• 2+ years of Automation Tech experience required. 
• Experience with Fisher, Rockwell, ABB, Allen Bradley and IDEC required.
• Knowledge of how to configure, calibrate and adjust control equipment and control device.
• Must live in Midland, Odessa, Crane, Stanton TX to be considered.
• High School Diploma or GED equivalent required. Valid Driver's License with an acceptable driving record required. 
• Must be able to pass all conditional job offer requirements including background check, drug screening, MVR, agility, fit for duty.
• Physical Requirements - Must be able to lift 40 lbs., climb ladders and stairs. Walking, bending stooping is required. Must be able to wear personal protective equipment. Must be able to respond to visual and audible alarms.
• Understanding of importance of environmental and safe work practices.